Evaporative Cooling Pumps
Evaporative Cooling Pumps
Continuous duty submersible pumps for dewatering or effluent evaporative cooling pumps for poultry applications.
Features and Benefits
- Cast iron motor and pump housing with corrosion-resistant, powder coated epoxy finish
- Motor - oil-filled, hermetically-sealed, automatic reset thermal overload protected
- Permanently lubricated upper and lower bearings
- Stainless steel screws and handle
- No sheet metal parts to rust or corrode
- No screens to clog
- Glass-filled, engineered plastic non-clogging vortex impeller with metal insert
- Watertight, neoprene square ring between motor and pump housing
- Silicon Carbide/Carbon shaft seal
- Entire unit pressure-tested after assembly
- Maximum temperature for effluent or dewatering: 130 °F (54 °C)
- 1-1/2" NPT Discharge
- Completely submersible
- Watertight and dust tight
Notes
Reserve Powered Design.
For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.
Product Specifications
Motor | 0.3 - 0.4 HP | |
Voltage | 115 or 230 V | |
Phase | 1 Ph | |
Hertz | 60 Hz | |
Amps | 3.2 - 9.7 Amps | |
Discharge Size | 1-1/2" NPT | |
Cord Length | 20 ft. (6 m) standard | |
Cord Type | UL listed power cord with molded 3-wire plug | |
Max Operating Temperature | 130 °F (54 °C) | |
Cooling | Oil filled | |
Motor Protection | Thermal overload | |
Motor Housing | Cast iron | |
Pump Housing | Cast iron | |
Upper Bearing | Permanently lubricated | |
Lower Bearing | Permanently lubricated | |
Impeller Type | Glass-filled, non-clogging vortex | |
Impeller | Engineered plastic with metal insert | |
Hardware | Stainless steel | |
|
Technical Data
Caution
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
Model Comparison Charts
- Product Model Comparison Chart: 60hz
model seal mode volts phase amps hp hz lbs kg 371-0002 Single Non 115 1 9.7 1/3 60 371-0004 Single Non 230 1 4.8 1/3 60 372-0002 Single Non 115 1 6.0 1/3 60 372-0004 Single Non 230 1 3.2 1/3 60 373-0002 Single Non 115 1 8.5 0.4 60 373-0004 Single Non 230 1 4.3 0.4 60 All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).