Welcome to our NEW website!

X

Model 75

img-title
Sump and Effluent Pumps // Residential Use // Builder

Model 75

BUILDER SERIES submersible pump for dewatering

Features and Benefits

  • Oil-filled, hermetically-sealed motor with automatic reset thermal overload protection
  • Rugged, cast iron motor housing with corrosion-resistant, baked-on enamel finish
  • Efficient heat sink for heat dissipation
  • Engineered plastic base and pump housing with no screen
  • Passes 3/8” (9.5 mm) spherical solids
  • Reliable integrated vertical switch
  • Carbon and ceramic rotary seal
  • Watertight, NBR rubber seal between motor and cover
  • Stainless steel screws and hardware
  • Temperature rating: 104 °F (40 °C)
  • On point: 8-1/3” (21 cm)
  • Off point: 2-1/2” (6.3 cm)
  • Maximum width: 8-3/32" (21 cm)
  • Maximum height: 12-3/8" (31.4 cm)
  • Weight: 16.5 lbs (7.5 kg)
  • Fits 12" (30 cm) diameter pits
  • 100% factory tested after assembly

Notes

Reserve Powered Design.
For unusual conditions a reserve safety factor is engineered into the design of every pump.

Product Specifications

60hz 50hz
Motor 1/2 HP
Voltage 115 V
Phase 1 Ph
Hertz 60 Hz
RPM 3450 RPM
Type Permanent split capacitor
Insulation Class B
Amps 5.6
Operation Automatic
Auto On / Off Points 8-1/4" (21 cm), 2-1/2" (6.3 cm)
Discharge Size 1-1/2" NPT
Solids Handling 3/8" (9 mm) spherical solids
Cord Length 10' (3 m) - 20' (6 m)
Cord Type UL listed with 3-wire, grounded plug
Max Head 25' (7.6 m)
Max Flow Rate 50 GPM (189 LPM)
Max Operating Temperature 104 °F (40 °C)
Cooling Oil filled
Motor Protection Auto reset thermal overload
Motor Housing Cast iron
Pump Housing Engineered plastic
Base Engineered plastic
Upper Bearing Ball bearing
Lower Bearing Ball bearing
Mechanical Seals Carbon and ceramic
Impeller Type Non-clogging vortex
Impeler Engineered plastic
Hardware Stainless steel
Motor Shaft SUS420J2 stainless steel
Gasket NBR
  • Cert Sa
  • Cert Tough
  • Cert Sspma
  • Cert 60Hz

Technical Data

CAUTION

All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

SELECTION GUIDE

  1. To select an appropriate basin, go to Basins.

Optional Pump Stand P/N 10-2421

ACCESSORIES

Model Comparison Charts

  • Product Model Comparison Chart: 60hz
    model seal mode volts phase amps hp hz lbs kg
    M75 Single Auto 115 0 5.6 1/2 60 16.5 7.5
    N75 Single Non 115 0 5.6 1/2 60 16.0 7.3
    BN75 Single Auto 115 0 5.6 1/2 60 17.5 7.9

Design Tools