North America / English Change

 

Aqua-Mate
Model 211

Submersible pumps for sewage/effluent or dewatering, pass 2" spherical solids, 2" NPT discharge.

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • Non-corrosive engineered plastic motor housing, pump housing, base and impeller
  • Oil free
  • No sheet metal parts to rust or corrode
  • All stainless steel screws, switch arm and lower motor housing
  • 2 pole float operated mechanical switch
  • Solid polypropylene float
  • Maximum temperature for dewatering: 110°F (43°C)
  • Passes 2" (50 mm) spherical solids
  • 2" NPT discharge
  • On point: 13" (33 cm)
  • Off point: 5-3/4" (14. 6cm)
  • Major width: 9-5/16" (23.7 cm)
  • Major height: 15-7/8" (40.3 cm)
  • All models completely submersible and hermetically sealed
  • Watertight and dust tight

Models available:

  • Automatic
  • Nonautomatic

Consult factory for special applications:

  • Variable level float switches available
  • Variable level long cycle systems available
  • Alarm systems available
Notes

Recommended for 2" pipe only

Note: The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with non-automatic pumps.


Reserve powered design.
For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.


 

 

HERTZ
60 Hz
MOTOR
0.4 HP
VOLTAGE
115 V
PHASE
1 Ph
RPM
3400 RPM
TYPE
Permanent split capacitor
INSULATION
Class B
AMPS
5.5 Amps
OPERATION
Automatic or nonautomatic
AUTO ON/ OFF POINTS
13" / 5-3/4" (33 cm / 14.6 cm)
DISCHARGE SIZE
2" NPT
SOLIDS HANDLING
2" (50 mm) spherical solids
CORD LENGTH
15' (5 m) standard
CORD TYPE
UL listed, 3-prong plug
MAX HEAD
19.5' (5.9 m)
MAX FLOW RATE
82 GPM (310 LPM)
MAX OPERATING TEMP
110° F (43° C)
COOLING
Oil free
MOTOR PROTECTION
Auto reset thermal overload
MOTOR HOUSING
Engineered plastic
PUMP HOUSING
Engineered plastic
BASE
Engineered plastic
UPPER BEARING
Ball bearing
LOWER BEARING
Ball bearing
MECHANICAL SEALS
Carbon and ceramic
IMPELLER TYPE
Non-clogging vortex
IMPELLER
Engineered plastic
HARDWARE
Stainless steel
MOTOR SHAFT
410 stainless steel
GASKET
Buna-N O-Ring
  • 54
  • 2
  • 11

Model Comparison Charts

Performance Curves

Dimensional Data Drawings

Caution

All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electric Code (NEC) and the Occupational Safety and Health Act (OSHA).

Selection Guide

  1. Integral float operated mechanical switch, no external control required.
  2. For automatic use single piggyback variable level float switch or double piggyback variable level float switch. Refer to FM0477.
  3. See FM1663for factory for residential alternator system.

Accessories

 

×
×