North America / English Change

 

X600 Series

Explosion-proof, submersible sewage or dewatering non-clog pumps.

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • FM and cCSAus rated Class I, Division 1, Group C & D environments
  • Non-clogging, semi-open, ductile iron impeller
  • Class 30 cast iron construction
  • All units are double seal for extra motor protection
  • Corrosion-resistant, powder coated epoxy finish
  • Stainless steel screws, washers, tags and seal assembly
  • Explosion-proof motor - 1750 RPM, hermetically-sealed and oil-filled for added heat dissipation
  • Thermal sensor
  • Continuous duty operation in submerged conditions
  • Maximum temperature for sewage or dewatering: 104° F (40° C) with 1.2 service factor (1.0 service factor on Model 661)
  • 416 stainless steel motor shaft
  • Tandem stainless steel fitted shaft seals with arbon and ceramic seal faces
  • Seal leak probes
  • Oversized upper and lower ball bearings running in oil bath
  • Buna N square rings and seals
  • All models pass 2-1/2” (63 mm) spherical solids
  • Major width: 17-9/16" (44.6 cm)
  • Major height: 33-1/4" (84.5 cm)
  • Specify 3” NPT vertical, 3” horizontal flanged or 4” horizontal flanged discharge
  • 100% computerized tested
  • Nonsparking rail systems available for all models
  • Intrinsically-safe control panels available
Notes

Reserve powered design.

For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.

HERTZ
60 Hz
MOTOR
1 - 7-1/2 HP
VOLTAGE
200 - 575 V
PHASE
1 or 3 Ph
RPM
1750 RPM
TYPE
Capacitor start / capacitor run or 3 phase
INSULATION
Class F
AMPS
1.6 - 28.0 Amps
OPERATION
Nonautomatic
DISCHARGE SIZE
3" NPT (optional 3" or 4" flange available)
SOLIDS HANDLING
2-1/2" (63 mm) spherical solids
CORD LENGTH
25' (8 m) standard
CORD TYPE
UL listed power and sensor cord
MAX HEAD
65' (19.8 m)
MAX FLOW RATE
600 GPM (2,271 LPM)
MAX OPERATING TEMP
104° F (40° C)
COOLING
Oil filled with finned housings
MOTOR PROTECTION
Thermal sensors and moisture sensors
CAP
Cast iron
MOTOR HOUSING
Cast iron
PUMP HOUSING
Cast iron
BASE
Cast iron
UPPER BEARING
Oversized ball bearing
LOWER BEARING
Oversized ball bearing
MECHANICAL SEALS
Carbon and ceramic with stainless steel parts
IMPELLER TYPE
Semi-open
IMPELLER
Ductile iron
HARDWARE
Stainless steel
MOTOR SHAFT
416 stainless steel
  • 54
  • 2
  • 4
  • 8
  • 12
  • 59

Warning

Not for use in acidic atmospheres.

Caution

All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electric Code (NEC) and the Occupational Safety and Health Act (OSHA).

Accessories

 

×

 

×