North America / English Change

 

Evaporative Cooling
370 Series

Continuous duty submersible pumps for dewatering or effluent evaporative cooling pumps for poultry applications.

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • Cast iron motor and pump housing with corrosion-resistant, powder coated epoxy finish
  • Motor - oil-filled, hermetically-sealed, automatic reset thermal overload protected
  • Permanently lubricated upper and lower bearings
  • Stainless steel screws and handle
  • No sheet metal parts to rust or corrode
  • No screens to clog
  • Glass-filled, engineered plastic non-clogging vortex impeller with metal insert
  • Watertight, neoprene square ring between motor and pump housing
  • Silicon Carbide/Carbon shaft seal
  • Entire unit pressure-tested after assembly
  • Maximum temperature for effluent or dewatering: 130°F (54°C)
  • 1½" NPT Discharge
  • Completely submersible
  • Watertight and dust tight

 

Notes
Reserve Powered Design.
For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.

HERTZ
60 Hz
MOTOR
0.3 - 0.4 HP
VOLTAGE
115 or 230 V
PHASE
1 Ph
AMPS
3.2 - 9.7 Amps
DISCHARGE SIZE
1½" NPT
CORD LENGTH
20 ft. (6 m) standard
CORD TYPE
UL listed power cord with molded 3-wire plug
MAX OPERATING TEMP
130°F (54°C)
COOLING
Oil filled
MOTOR PROTECTION
Thermal overload
MOTOR HOUSING
Cast iron
PUMP HOUSING
Cast iron
UPPER BEARING
Permanently lubricated
LOWER BEARING
Permanently lubricated
IMPELLER TYPE
Glass-filled, non-clogging vortex
IMPELLER
Engineered plastic with metal insert
HARDWARE
Stainless steel
  • 54
  • 2
  • 8
  • 11
  • 15

Caution

All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

Accessories

 

×
×