Latin America / English Change

 

3000 High Temperature

Submersible pumps for use in dewatering applications up to 200° F (93° C).

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • A high temperature submersible pump series with electrical components meeting the National Electrical Code requirements for 200° F (93°C) service
  • Comprehensive line of models, styles and modes
  • Conduit length is 3' (0.9 m) for automatic models and 6' (1.8 m) for nonautomatic models
  • Power cord length is 15' (5 m) for automatic models and supplied by others for nonautomatic models
  • High temperature liquid-tight conduit used with high temperature cable
  • High temperature motor windings
  • High temperature Viton® gaskets
  • High temperature thermal overload protected
  • All control components in contact with water are high temperature rated
  • All models have stainless steel screws, guards, handles and control arm and seal assemblies
  • Float-operated mechanical switch box, which is mounted on the discharge pipe above the operating level (switch box is not intended to come in continuous contact with 200° F [93°C] water)
  • Mechanical seal has NI-Resist rotary face and Viton® elastomer
  • Corrosion-resistant, powder coated epoxy finish
Notes

Notes:

  1. Cable from disconnect to control box (customer furnished) should be rated 105°C (221°F).
  2. Nonautomatic models available with 6 ft (1.8 m) of high temperature liquid-tight conduit cable (200° F/93°C) and a watertight junction box for outdoor or above the waterline installation.
  3. The maximum 'On' levels can be extended for automatic pumps by adding additional cord and conduit length. Float rods are extended in 1 ft increments. Order an extender kit P/N 10-0656 for each additional foot of length desired.
  4. Caution: Check valves used in high temperature service must be all metal swing type check valves.
  5. Caution: The basin material must be able to withstand the sustained, elevated temperature anticipated.

 

HERTZ
60 Hz
MOTOR
1/2 HP
VOLTAGE
115 or 230 V
PHASE
1 Ph
AMPS
4.7 - 15.5 Amps
CORD LENGTH
15' (5 m) standard
MAX OPERATING TEMP
200° F (93° C)
MOTOR PROTECTION
High Temperature thermal overload
IMPELLER TYPE
Vortex
GASKET
High temperature viton
  • 54
  • 8

Caution

All installation of controls, protection devices and wiring should be installed by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

 

×

 

×