Latin America / English Change

 

Evaporative Cooling
370 Series

Continuous duty submersible pumps for dewatering or effluent evaporative cooling pumps for poultry applications.

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • Cast iron motor and pump housing with corrosion-resistant, powder coated epoxy finish
  • Motor - oil-filled, hermetically-sealed, automatic reset thermal overload protected
  • Permanently lubricated upper and lower bearings
  • Stainless steel screws and handle
  • No sheet metal parts to rust or corrode
  • No screens to clog
  • Glass-filled, engineered plastic non-clogging vortex impeller with metal insert
  • Watertight, neoprene square ring between motor and pump housing
  • Silicon Carbide/Carbon shaft seal
  • Entire unit pressure-tested after assembly
  • Maximum temperature for effluent or dewatering: 130°F (54°C)
  • 1½" NPT Discharge
  • Completely submersible
  • Watertight and dust tight

 

Notes
Reserve Powered Design.
For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.

HERTZ
60 Hz
MOTOR
0.3 - 0.4 HP
VOLTAGE
115 or 230 V
PHASE
1 Ph
AMPS
3.2 - 9.7 Amps
DISCHARGE SIZE
1½" NPT
CORD LENGTH
20 ft. (6 m) standard
CORD TYPE
UL listed power cord with molded 3-wire plug
MAX OPERATING TEMP
130°F (54°C)
COOLING
Oil filled
MOTOR PROTECTION
Thermal overload
MOTOR HOUSING
Cast iron
PUMP HOUSING
Cast iron
UPPER BEARING
Permanently lubricated
LOWER BEARING
Permanently lubricated
IMPELLER TYPE
Glass-filled, non-clogging vortex
IMPELLER
Engineered plastic with metal insert
HARDWARE
Stainless steel
  • 54
  • 2
  • 8
  • 11
  • 15
HERTZ
50 Hz
MOTOR
0.56 - 0.72 KW
VOLTAGE
220 V
PHASE
1 Ph
RPM
1300 or 2800 RPM
TYPE
Shaded pole, permanent split capacitor
INSULATION
Class B
AMPS
3.4 - 6.0 Amps
OPERATION
Nonautomatic
DISCHARGE SIZE
1-1/2" NPT
SOLIDS HANDLING
12 mm (1/2"), 19 mm (3/4") spherical solids
CORD LENGTH
8 m (25') standard
CORD TYPE
H07RN-F
MAX HEAD
9.8 m (32')
MAX FLOW RATE
13.4 m3/hr (59.2 GPM)
MAX OPERATING TEMP
54° C (130° F)
COOLING
Oil filled
MOTOR PROTECTION
Auto reset thermal overload
CAP
Cast iron
MOTOR HOUSING
Cast iron
PUMP HOUSING
Cast iron
BASE
Engineered thermoplastic
UPPER BEARING
Sleeve bearing
LOWER BEARING
Sleeve or ball bearing
MECHANICAL SEALS
Silicon carbide / carbon
IMPELLER TYPE
Non-clogging vortex
IMPELLER
Engineered thermoplastic
HARDWARE
Stainless steel
MOTOR SHAFT
AISI 1215 steel
GASKET
Neoprene
  • 14
  • 28
  • 8

Caution

All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

Accessories

 

×

 

×