Europe, Middle East and Africa / English Change

 

Shark®
Model 800

1/2 HP grinder

 
 
Features andBenefits
ProductSpecifications
TechnicalData
Literature and Documents

  • Efficient 115 volt, ½ HP, 60 Hz, 7 amp motor allows for installation with a standard 15 amp circuit.
  • Tri-Slice® cutter technology - three independent cutting channels provide over 250,000 cuts/minute.
  • Stainless steel cutter and plate
  • 15' (5 m) power cord
  • Stainless braided lift handle standard
  • 1¼" NPT discharge can be adapted to existing 2" piping systems.
  • Automatic thermal overload
  • Maximum operating temperature 130° F (54° C)
  • Cast iron motor housing and pump housing provides heat dissipation for extended life cycle and durability.
  • Weight is less than 30 lbs (13.6 kg) providing for ease of installation.
  • No control panel required. Internal start components.
  • Upper and lower bearings provide smooth operation and durability in the harshest environments.
  • 100% factory tested

HERTZ
60 Hz
MOTOR
1/2 HP
VOLTAGE
115 V
PHASE
1 Ph
RPM
3450 RPM
TYPE
Capacitor start/capacitor run
INSULATION
Class B
AMPS
7.0 Amps
OPERATION
Automatic and nonautomatic
AUTO ON/ OFF POINTS
13-3/8" / 6-1/2" (34 cm / 16.5 cm)
DISCHARGE SIZE
1-1/4"
CORD LENGTH
15' (5 m) standard
CORD TYPE
18-3 SJTW
MAX HEAD
26' (7.9 m)
MAX FLOW RATE
46 GPM (10.4 m3/hr)
MAX OPERATING TEMP
130° F (54° C)
COOLING
Oil filled
MOTOR PROTECTION
Automatic thermal overload
CAP
Engineered plastic
MOTOR HOUSING
Upper-engineered plastic
PUMP HOUSING
Lower-cast iron
UPPER BEARING
Ball bearing
LOWER BEARING
Ball bearing
MECHANICAL SEALS
Carbon and ceramic
IMPELLER TYPE
Non-clogging vortex
IMPELLER
Engineered thermoplastic
HARDWARE
Stainless steel
MOTOR SHAFT
AISI 1215 carbon steel
GASKET
Buna-N O-ring
  • 54
  • 2
  • 8

Model Comparison Charts

Performance Curves

Dimensional Data Drawings

 

×

 

×