Your Peace of Mind is Our Top Priority

• FM listed motor for Class 1, Division 1, Group C & D environments
• Non-clogging vortex impeller design bronze class 88-8-0-4
• Stainless steel rotor shaft
• Sensor leads and power leads in one cord for easy installation.
• Durable cast iron (class 30, 30000# tensile strength) constructed cover, motor adapter and pump housing
• Stainless steel screws and handle
• No sheet metal parts to rust or corrode
• Threaded conduit connection for protecting cords in extra heavy duty applications
• Moisture sensors prewired in motor housing (requires indicator in panel)
• Zoeller custom designed mechanical switch or panel with intrinsically safe relays and moisture indicator is required
• 3 Phase models available
• Oil-filled, hermetically sealed motor, automatic reset thermal overload protected (3 Phase requires circuit in control panel)
• Maximum temperature for sewage or dewatering 104°F (40°C)
• Shaft Seal: stainless steel wetted parts, carbon and ceramic rotary face seal
• Upper ball bearing and lower ball bearing running in bath of oil
• Buna N square ring seals
• All models pass 3” spherical solids
• Major width: 16 1/8"
• Major height: 25 15/16"
• Available in nonautomatic units only
• 4” horizontal flanged discharge, standard ANSI flanged
• 100% submerged and computerized tested
• Corrosion resistant powder coated epoxy finish
• Nonautomatic models for variable level systems

Note: The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with non-automatic pumps.

Reserve powered design.

For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump.

*See charts for FM listings.